Adjustment
13 - 21
13.05.18 Knife pressure
Requirement
When the point of the thread catcher 4 is 6 mm in front of the front edge of the knife 4,
the cutting edge of the knife must lightly press against the thread catcher 4.
6 mm
4
5
6
2
1
3
● Bring the take-up lever to BDC.
● Press the roller lever 1 into the control cam 2.
● Turn the handwheel 3 in the direction of the arrow until the thread catcher 4 is
approx. 4 mm in front of the knife 4.
● Move the knife 5 (screws 6) according to the requirement.
● Check requirement 1 from chapter 13.05.17 Thread catcher position and knife
height.
Fig. 13 - 19
To Next Page
Loading...
