Adjustment
13 - 15
13.05.12 Counter presser height
Requirement
When the needle bar is at BDC, the top edge of the counter presser 6
must be 1 mm
over the closed hook compartment cover 3.
● Position lever 1 (nut 2) at its lower stop (see arrow).
● Fit hook compartment cover 3 and turn bracket 4 (screw 5) according to the
requirement.
If necessary, the presser lift can be increased by moving the lever
1 upwards.
After adjusting the lift, the presser height should also be regulated!
Fig. 13 - 13
1
2
4
5
3
1 mm
6
To Next Page
Loading...
