Adjustment
13 - 31
● Select TURN SEWING MOTOR function.
● Set the speed to 4000 min
-1
using the number keys.
When the sewing motor is running, do not reach into the needle area!
Danger of injury by the moving parts!
● Confirm input with the Enter key.
● Select the start function.
● Allow the sewing motor to run for 2-3 min.
● While the motor is running, hold a paper strip 4 next to the hook and check the
requirement.
● If necessary, adjust the oil supply with screw 2.
● Switch the machine off and screw on the hook compartment cover.
The wick used for lubricating the front parts must always be impregnated with
oil. However, oil must not drip onto the bedplate!
● If necessary, adjust the amount of oil with screw 3.
1
Enter
To Next Page
Loading...
