11 - 9
Input mode functions
Parts program functions (number key 9)
Opens a menu for entering values which refer to the material and size of the pieces to be
worked (see chapter 9.09 Changing the part set).
The values are automatically attributed to the selected parts program (see Chapter 11.05,
section: Program Number Selection).
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 13
<- - - - >
1 - ROLLING DIRECTION STACKER: BACKWARDS
2 - SLOW ROLLING TIME STACKER: 0.50 s
3 - FAST ROLLING TIME STACKER: 0.35 s
4 - TIME FOR STACK TRESTLE BACK: 0.0 s
5 - TIME FOR EDGE FOLDERS BACK: 0.10 s
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 14
<- - - - >
6 - TIME FOR POCKET PLATE UP 0.50s
7 - FEED SPEED: 100%
8 - SEAM CORRECTION X: 0.2 mm
9 - SEAM CORRECTION Y: 0.5 mm
1
SLOW ROLLING TIME STACKER
For entering the rolling time of the slow rolling movement of the stacker roller
(see Fig. 11-15).
FAST ROLLING TIME STACKER
For entering the rolling time of the fast rolling movement of the stacker roller
(see Fig. 11-15).
Fig. 11 - 15
workpiece
slow rolling time,
correct rolling direction
slow rolling time,
change rolling direction
if necessary
2
3
stacker frame
ROLLING DIRECTION STACKER
With this function, the direction in which the stacker roller is to roll slowly is
determined (see Fig. 11-15).
To Next Page
Loading...
