11 - 5
Input mode functions
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 05
1 - WRITE MACHINE DATA ON DISK
2 - READ MACHINE DATA FROM DISK
3 - CARRY OUT COLD START
4 - DISPLAY SOFTWARE STATUS
5 - CONTRAST SETTING OF DISPLAY
6 - CHANGE CODE NUMBER
● Select the CONTRAST SETTING OF DISPLAY function (number key 5).
● If required, enter the 4-digit code number via the number keys.
5
INPUT mode
Input menu function (number key 0)
1- PROGRAM MANAGEMENT ....
2- CREATE / MODIFY PROGRAM
3- COUNTER ....
4- SWITCH FUNCTIONS ....
5- TIMES ....
6- SERVICE
2- STEPPING MOTOR FUNCTIONS ....
4- DISPLAY INPUTS / OUTPUTS
1- SEWING DRIVE FUNCTIONS ....
6- CONFIGURE MACHINE ....
7-OTHER FUNCTIONS
3- SWITCH OUTPUTS
5- ADJUST ZERO POINT ....
2- READ MACHINE DATA FROM DISK
4- DISPLAY SOFTWARE STATUS
6- CHANGE CODE NUMBER
5- CONTRAST SETTING OF DISPLAY
6
7
5
0
3- CARRY OUT COLD START
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 06
CONTRAST SETTING:
ADJUST WITH +,- KEYS
The contrast setting changes when the plus/minus keys are pressed and does
not have to be confirmed with Enter. Do not lower the contrast setting to the
extent that the display cannot be read anymore!
● Change the contrast setting as desired by pressing the plus/minus keys.
● Press Enter to exit the function.
Enter
Summary of the function selections
1- WRITE MACHINE DATA ON DISK
To Next Page
Loading...
