Pfaff 3588-04/020 - Page 68

Input mode functions
11 - 18
SEWING DRIVE FUNCTIONS
Opens a menu where you can test the sewing motor:
1
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 30
1 - TURN SEWING MOTOR
2 - THREAD TRIMMING PROCEDURE
3 - CUTTING SPEED - PRE-SEL.: 200 RPM
Before performing the following functions please make sure that the
needle can penetrate the needle hole without being obstructed!
TURN SEWING MOTOR
Starts and stops the sewing motor. The speed can either be preselected or
changed via the plus/minus keys while the motor is running.
THREAD TRIMMING PROCEDURE
Starts the thread trimming procedure.
CUTTING SPEED - PRE-SEL.
Pre-selects the positioning speed for thread cutting.
STEPPING MOTOR FUNCTIONS
Opens a menu where you can move the stepping motors:
1
2
3
2
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 31
1 - STEPPING MOTOR 1
2 - STEPPING MOTOR 2
3 - MOVE CARRIAGE
4 - TEST CARRIAGE
Before performing the following functions, make sure that the
sewing jig feed moves without being obstructed!
STEPPING MOTOR 1
Moves stepping motor 1.
STEPPING MOTOR 2
Moves stepping motor 2.
MOVE CARRIAGE
Moves the sewing jig feed.
TEST CARRIAGE
(presently no function)
Tests the sewing jig feed.
1
2
3
4