Fig. 11 - 34
1 - WRITE MACHINE DATA ON DISK
2 - READ MACHINE DATA FROM DISK
3 - CARRY OUT COLD START
4 - DISPLAY SOFTWARE STATUS
5 - CONTRAST SETTING OF DISPLAY
6 - CHANGE CODE NUMBER
7
1
WRITE MACHINE DATA ON DISK
Writes the data of the machine configuration (file name: MDAT) on a disk.
For a table of all transferable machine data please refer to
chapter 14.03.02 Table of machine data (MDAT).
READ MACHINE DATA FROM DISK
Reads machine data which are stored on a disk into the machine memory (e.
g. after a cold start).
CARRY OUT COLD START
Carries out a cold start.
When carrying out a cold start, all settings except the zero point and the
machine configuration settings are reset to boot-up values. All programs in
the machine memory are deleted.
DISPLAY SOFTWARE STATUS
Displays the date of origin of the machine software and the software
versions of various control units.
CONTRAST SETTING OF DISPLAY
Do not lower the contrast setting to such an extent that the
display becomes illegible!
This function lets you change the contrast setting of the display.
CHANGE CODE NUMBER
After a cold start, the code number is 3588. This function lets you choose
your own code number between 0000 - 9999.
Functions which are secured by a code number can only be
selected via the respective code.
2
3
4
5
6
To Next Page
Loading...
