Input mode functions
11 - 32
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 46
PROGRAM NUMBER : 4034
[ PERMISSIBLE 0 - 9999 ]
● Enter the desired program number via the number keys (e. g. 500 for a seam program to
be created)
● Confirm by pressing Enter.
Fig. 11 - 47
X: 2500 Y: 0 1 : PROGRAM NUMBER
# 500
● Move step by step through the program header over the section „Obstructions“ with the
number keys 1 or 2, until you find the display where you can input the jig code (in this
case, „obstructions“ means that additional devices have been attached to the sewing jig,
e.g. a variable sewing slot).
0
Enter
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
5
0
Fig. 11 - 48
X: 2500 Y: 0 2 : JIG CODE
● Select the Change function to change the setting for the jig code (number key 9).
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 49
● Press number key 1 to switch the jig code on.
● Press right arrow key to be able to enter the jig-code number.
(The cursor jumps to CODE: __.)
● Enter the jig-code number via the number keys (e. g. 99).
● Confirm by pressing Enter.
1
JIG CODE : OFF CODE: _ _
0- OFF
1- ON
Enter
9
9
To Next Page
Loading...
