Wide pedal: You can temporarily activate the manual chip blow by pushing
and holding the pedal to the right.
The flow of air will continue until you remove your foot from the pedal.
NOTE
The type of manual chip blow does not depend on the type of the automatic
chip blow, but is always dry. The manual chip blow can be set to be
dependent on programming; contact your Planmeca dealer.
23.2.8 Instrument light
When the instrument light is on, the indicator light on the control panel button
is green.
Control panel: Press Instrument light to switch the instrument light on/off.
NOTE
The foot control can be configured so that you push the left-side knob down
to switch the instrument light on/off. Contact your Planmeca dealer.
NOTE
Check the indicator light on the control panel to verify that pushing the left-
side knob down activates the correct function.
The instrument light intensity can be programmed, see section "Instrument
light" on page 178.
23 Operating instruments
136 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
