10.6.2 Setting up sterile water system
Before using sterile water, you need to set up the sterile water system as
described below and edit the instrument spray settings so that sterile water
is used (see section "Enabling/disabling sterile water mode" on page 177).
1. Hang the sterile water bag on the holder.
In OP-deliveries, the holder is attached on the pylon, and in side and cart
deliveries it is attached to the instrument console.
2. Open the lid of the water pump and place the silicone part of the sterile
water tube in the pump.
10 Instrument system
50 Planmeca Compact i User's manual
To Next Page
Loading...
