Planmeca Compact i Touch v2 User Manual

NOTE
If you disable the sterile water mode for an instrument that uses sterile
water, the flow rate for sterile water 1 and 2 automatically changes to
0%.
5. Press OK.
The pop-up window closes.
25.4.4 Automatic chip blow
About this task
NOTE
The type of manual chip blow does not depend on the type of the automatic
chip blow, but is dry as a factory default. The manual chip blow can be set to
be dependent on programming, contact your Planmeca dealer.
Steps
1. Activate the instrument.
2. Press Program.
3. Press Chip blow.
A pop-up window opens.
4. Adjust the flow rates for water and air.
The minimum value of both parameters is 0 (no flow) and maximum 100.
The adjustment step is 1 in the value range 0 - 35% and 5 in the value
range 35 - 100%.
5. Press OK.
The pop-up window closes and the new values are displayed on the
control panel.
25.4.5 Instrument light
Steps
1. Activate the instrument.
2. Press Program.
25 Programming
178 Planmeca Compact i User's manual

Planmeca Compact i Touch v2 Specifications

General

Brand	Planmeca
Model	Compact i Touch v2
Category	Medical Equipment
Language	English