10.4.1 Instrument spray
The instrument spray can be programmed to be on or off when the
instrument is active (i.e. picked up from the instrument console). Also, the
type of spray can be programmed.
For more information, see section "Instrument spray" on page 176.
10.4.2 Automatic chip blow
The automatic chip blow can be programmed to be on or off when the
instrument is active (i.e. picked up from the instrument console). Also, the
type of automatic chip blow can be programmed.
For more information, see section "Automatic chip blow" on page 178.
10.4.3 Instrument light
The instrument light can be programmed so that it will either be on or off
when an instrument is active (i.e. picked up from the instrument console).
Also, the intensity can be adjusted. For more information, see section
"Instrument light" on page 178.
The instrument light can be on only in one instrument at a time, for example,
the instrument light of the syringe will switch off, if the light of the active
instrument is switched on.
10.4.4 Reverse rotation of micromotor
The direction of the micromotor rotation can be reversed, see section
"Reverse rotation" on page 133.
10.4.5 Quickstart of air driven instruments
The turbine can be set to start with maximum speed, see section
"Quickstart" on page 154.
10.4.6 Instrument speed/power limit
The instrument speed/power limit can be set to be on or off when the
instrument is active (i.e. picked up from the instrument console), see
sections "Speed/power limit" on page 133 (micromotor), "RPM limit" on page
138 (Bien-Air MCX micromotor), "RPM" on page 140 (Bien-Air MX2
micromotor), "RPM" on page 142 (Morita TORX micromotor) and "Speed/
power limit" on page 156 (turbine).
The power reduction level can be programmed, see sections "Instrument
speed/power limit" on page 176 (micromotor and turbine), "Bien-Air MCX
micromotor" on page 179, "Modifying preset values" on page 180 (Bien-Air
MX2 micromotor) and "Modifying preset values" on page 184 (Morita TORX
micromotor).
NOTE
The instrument speed/power limit does not affect the air driven instruments
for which quickstart has been selected.
10.4.7 Torque limit
The torque limit for the Bien-Air MCX, Bien-Air MX2 and Morita TORX
micromotors can be set to be on or off when the instrument is active (i.e.
picked up from the instrument console), see sections "Torque limit" on page
10 Instrument system
42 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
