3. Press Instrument light.
A pop-up window opens.
4. Adjust the light intensity.
The minimum value is 70% of the maximum intensity and the maximum
100%, and the adjustment step is 2.
After reaching the minimum value the light is switched off.
5. Press OK.
The pop-up window closes and the new values are displayed on the
control panel.
25.4.6 Bien-Air MCX micromotor
About this task
Changing the instrument spray, chip blow and LED values for the Bien-Air
MCX micromotor follows the normal programming pattern. For more
information, see sections "Instrument spray" on page 176, "Automatic chip
blow" on page 178 and "Instrument light" on page 178.
CAUTION
Before modifying the torque and RPM functions, please refer to the file
manufacturer’s instructions concerning torque and RPM value
recommendations for the files.
Steps
1. Activate the micromotor.
2. Press Torque.
The micromotor's drive mode is automatically set to Auto stop. This
means, that when the torque limit is reached, the micromotor stops. No
other drive modes are available for the Bien-Air MCX micromotor.
3. Press Program.
4. Press RPM limit to adjust the micromotor speed rate.
A pop-up window opens.
25 Programming
User's manual Planmeca Compact i 179
To Next Page
Loading...
Need help?
General
