28.5 Suction system
NOTE
Dry the suction tube holders and the tube bushings properly after cleaning.
Wet surfaces might disturb suction tube recognition.
28.5.1 In the morning
Steps
1. Rinse each suction tube with 0.5 litres of water by slowly aspirating water
and air through the suction handpieces.
2. Wipe the suction handpieces with Planmeca approved surface
disinfectant.
28.5.2 After each patient
Steps
1. Remove the used aspirating tips.
2. For hygienic and operational reasons, empty one glass of water (100 -
200 ml) with each suction tube by aspirating water and air through the
suction handpiece. Do this even if only the saliva suction tube has been
used.
3. Wipe the suction handpieces with Planmeca approved surface
disinfectant.
4. Wipe the suction holder / Flexy-holder, including the tablet holder, with
Planmeca approved surface disinfectant.
Results
NOTE
Do not use a spray disinfection solution for the suction arms and holders.
NOTE
Clean the tablet according to the instructions given by the manufacturer.
28 Cleaning and disinfection
234 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
