The amount of water and the spray water number (1 or 2) are displayed on
the control panel.
When sterile water is used, you can select between sterile water spray and
spray off. Sterile water is indicated by a Sterile water symbol and the
indicator light blinks green on the Instrument spray button.
For instructions on how to enable/disable the sterile mode, see section
"Enabling/disabling sterile water mode" on page 177.
Press Instrument spray once to switch on water 1. You will hear two short
signal tones. Additionally, a green indicator light shows that water 1 is
switched on.
Press Instrument spray a second time to switch on water 2. You will hear
one short signal tone. Additionally, a yellow indicator light shows that water 2
is switched on.
Press Instrument spray a third time to switch off the instrument spray. You
will hear one long signal tone. Additionally, the indicator light goes out.
Alternatively, you can select the spray setting with the foot control. The
indicator lights on the control panel are lit accordingly.
Standard pedal: Push the pedal down briefly to select the spray setting.
Wide pedal: Push the pedal briefly to the left to select the spray setting.
Push the pedal once to switch on water 1. You will hear two short signal
tones.
Push the pedal again to switch on water 2. You will hear one short signal
tone.
Push the pedal a third time to switch off the instrument spray. You will hear
one long signal tone.
23 Operating instruments
User's manual Planmeca Compact i 159
To Next Page
Loading...
Need help?
General
