5. Press and hold down the handle of the foot control that you want to pair
your dental unit with to select it.
The selected foot control is shown with a black font on the list (marked
with arrow in the picture below).
The foot control that is highlighted in blue is the currently paired foot
control.
NOTE
For information on the different markings in the
Bind foot control
window,
press Questionmark.
6. While holding the handle down, start pairing by touching the name of the
selected foot control (black font) on the list.
A confirmation message is displayed on the dental unit’s control panel.
7. Press OK to confirm the start of the pairing process.
8. Release the foot control handle.
Once the pairing is done, a message is displayed on the dental unit’s
control panel and the paired foot control is highlighted in blue on the list.
If the pairing is not successful, you will receive a notification, after which
you can retry to perform the pairing.
9. Press OK to close the window.
25 Programming
User's manual Planmeca Compact i 197
To Next Page
Loading...
Need help?
General
