Planmeca Compact i3 User Manual

24.4.3 Enabling/disabling sterile water mode
About this task
If the dental unit is equipped with the Planmeca Sterile water system or
Steripump, enable/disable the sterile water mode as described below.
NOTE
The flow rates for sterile water can not be adjusted by the user.
Steps
1. Activate the instrument.
2. Press Program.
3. Press Instrument spray.
A pop-up window opens.
4. Toggle the Sterile water button to enable/disable the sterile water mode.
A grey button means that the sterile water mode is disabled, and a blue
button that it is enabled.
NOTE
If you disable the sterile water mode for an instrument that uses sterile
water, the flow rate for sterile water 1 and 2 automatically changes to
0%.
5. Press OK.
The pop-up window closes.
24.4.4 Automatic chip blow
About this task
NOTE
The type of manual chip blow does not depend on the type of the automatic
chip blow, but is dry as a factory default. The manual chip blow can be set to
be dependent on programming, contact your Planmeca dealer.
Steps
1. Activate the instrument.
24 Programming
User's manual Planmeca Compact i3 153

Planmeca Compact i3 Specifications

General

Brand	Planmeca
Model	Compact i3
Category	Dental equipment
Language	English