Planmeca Compact i3 User Manual

2. Press Program.
3. Press Chip blow.
A pop-up window opens.
4. Adjust the flow rates for water and air.
The minimum value of both parameters is 0 (no flow) and maximum 100.
The adjustment step is 1 in the value range 0 - 35% and 5 in the value
range 35 - 100%.
5. Press OK.
The pop-up window closes and the new values are displayed on the
control panel.
24.4.5 Instrument light
Steps
1. Activate the instrument.
2. Press Program.
3. Press Instrument light.
A pop-up window opens.
4. Adjust the light intensity.
The minimum value is 70% of the maximum intensity and the maximum
100%, and the adjustment step is 2.
After reaching the minimum value the light is switched off.
5. Press OK.
The pop-up window closes and the new values are displayed on the
control panel.
24.4.6 Bien-Air MCX micromotor
About this task
Changing the instrument spray, chip blow and LED values for the Bien-Air
MCX micromotor follows the normal programming pattern. For more
24 Programming
154 Planmeca Compact i3 User's manual

Planmeca Compact i3 Specifications

General

Brand	Planmeca
Model	Compact i3
Category	Dental equipment
Language	English