Planmeca Compact i3 User Manual

10.4.1 Instrument spray
The instrument spray can be programmed to be on or off when the
instrument is active (i.e. picked up from the instrument console). Also, the
type of spray can be programmed.
For more information, see section "Instrument spray" on page 152.
10.4.2 Automatic chip blow
The automatic chip blow can be programmed to be on or off when the
instrument is active (i.e. picked up from the instrument console). Also, the
type of automatic chip blow can be programmed.
For more information, see section "Automatic chip blow" on page 153.
10.4.3 Instrument light
The instrument light can be programmed so that it will either be on or off
when an instrument is active (i.e. picked up from the instrument console).
Also, the intensity can be adjusted. For more information, see section
"Instrument light" on page 154.
The instrument light can be on only in one instrument at a time, for example,
the instrument light of the syringe will switch off, if the light of the active
instrument is switched on.
10.4.4 Reverse rotation of micromotor
The direction of the micromotor rotation can be reversed, see section
"Reverse rotation" on page 108.
10.4.5 Quickstart of air driven instruments
The turbine can be set to start with maximum speed, see section
"Quickstart" on page 129.
10.4.6 Instrument speed/power limit
The instrument speed/power limit can be set to be on or off when the
instrument is active (i.e. picked up from the instrument console), see
sections "Speed/power limit" on page 108 (micromotor), "RPM limit" on page
113 (Bien-Air MCX micromotor), "RPM" on page 115 (Bien-Air MX2
micromotor), "RPM" on page 117 (Morita TORX micromotor) and "Speed/
power limit" on page 131 (turbine).
The power reduction level can be programmed, see sections "Instrument
speed/power limit" on page 151 (micromotor and turbine), "Bien-Air MCX
micromotor" on page 154, "Modifying preset values" on page 156 (Bien-Air
MX2 micromotor) and "Modifying preset values" on page 159 (Morita TORX
micromotor).
NOTE
The instrument speed/power limit does not affect the air driven instruments
for which quickstart has been selected.
10.4.7 Torque limit
The torque limit for the Bien-Air MCX, Bien-Air MX2 and Morita TORX
micromotors can be set to be on or off when the instrument is active (i.e.
picked up from the instrument console), see sections "Torque limit" on page
10 Instrument system
User's manual Planmeca Compact i3 31

Planmeca Compact i3 Specifications

General

Brand	Planmeca
Model	Compact i3
Category	Dental equipment
Language	English