24.4.7.2 Saving modified preset values
About this task
When you have modified the Bien-Air MX2 instrument settings, you can
store them under any preset (1 - 6) so that the modified settings are in use
next time you select that preset.
Steps
1. Press Program.
2. Press Preset to open a list of presets.
3. Press the preset under which you want to store the modified settings.
The preset window is closed. The settings are stored in the dental unit
when you return the instrument to its holder.
24.4.8 Morita TORX micromotor
24.4.8.1 Modifying preset values
About this task
If you want to modify the presets presented in section "Presets" on page
118, you can do so by following the steps below.
Steps
1. Activate the micromotor.
2. All presets: Adjust the RPM limit.
2.a. Press Program.
2.b. Press RPM limit.
A pop-up window opens.
2.c. Set the RPM limit.
2.d. Press OK.
The pop-up window closes and the new value is displayed on the
control panel.
24 Programming
User's manual Planmeca Compact i3 159
To Next Page
Loading...
