Planmeca Compact i3 User Manual

6. Connect the water tube to the instrument by sliding the tube over the
externally mounted spray nozzle as shown in the figure below.
7. Attach the long end of the sterile water tube to the OP delivery arm with
the clips included in the sterile water tube package.
8. Enable sterile water from the instrument spray settings. See section
"Enabling/disabling sterile water mode" on page 153.
10.6.3 Extending sterile water tube
If the sterile water tube is too short, you can extend it with one or two
extension tubes, depending on how long a sterile water tube you need.
The following instructs how to join two extension tubes with the sterile water
tube before routing the tube from the instrument to the sterile water bag, but
note that you may well use only one extension tube, provided it gives you
the required length. You may also cut the extension tube shorter, if needed.
1. Cut the sterile water tube at location marked with (1) in picture.
2. Attach the two extension tubes to each other with a tube joint (provided
with extension tube pack) (2). This creates the joint extension tube.
3. Attach one end of the joint extension tube to the sterile water tube with
nozzle (3).
10 Instrument system
User's manual Planmeca Compact i3 37

Planmeca Compact i3 Specifications

General

Brand	Planmeca
Model	Compact i3
Category	Dental equipment
Language	English