To enter the Maintenance mode, press the Maintenance button.
The
Maintenance
window shows the different cleaning programs.
NOTE
If the value of the manual suction cleaning time has been adjusted to smaller
than 60 s, manual suction cleaning is disabled and does not show on the
maintenance menu. To adjust the manual suction cleaning time, see section
"Adjusting maintenance functions" on page 169.
The time stamp under the cleaning program name is an easy way to check
when the cleaning program was last started. However, it does not tell
whether the cleaning program was successfully completed.
While performing the flushing/cleaning, follow the instructions displayed on
the control panel. When the cleaning program runs without problems, the
messages only show briefly, but all messages can be viewed in the
message history log.
To view the message history log, see section "Viewing help and error
message history" on page 223.
Some control panel buttons are common for all cleaning programs, see the
following table.
26 Flushing and cleaning programs
174 Planmeca Compact i3 User's manual
To Next Page
Loading...
