EasyManuals Logo

Planmeca ProMax Technical Manual

Planmeca ProMax
378 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
TABLE OF CONTENTS
2 Planmeca ProMax
Technical Manual
5 SERVICE SETTINGS .................................................................................B-24
5.1 Special operation mode selection .............................................................B-25
5.2 Preheat calibration ....................................................................................B-26
5.3 Maximum height........................................................................................B-26
5.4 Exposure program tuning..........................................................................B-27
5.5 Factory default settings .............................................................................B-28
5.6 Configuration selftest ................................................................................B-29
5.7 Select configuration...................................................................................B-29
5.8 Patient support alignment .........................................................................B-34
5.9 Software update........................................................................................B-34
6 TECHNICAL CALIBRATIONS ..................................................................B-35
6.1 Collimator speed adjustment.....................................................................B-36
6.2 Height adjustment maximum speed setting ..............................................B-37
6.3 QA exposure .............................................................................................B-37
6.4 DAP value adjustments.............................................................................B-38
7 TROUBLESHOOTING ..............................................................................B-39
7.1 Dimax communication...............................................................................B-40
7.2 Network status ..........................................................................................B-41
7.3 3D sensor communication.........................................................................B-41
8 ENTERING THE PASSWORD....................................................................B-42
Chapter C HELP & ERROR MESSAGES
1 MAIN CATEGORIES ................................................................................ C-1
2 HELP MESSAGES ..................................................................................... C-2
3 ERROR MESSAGES .................................................................................. C-4
3.1 Motorized motion related errors (2xx) ........................................................ C-4
3.2 X-ray generation related errors (3xx) ......................................................... C-7
3.3 Feedback errors (4xx) .............................................................................. C-10
3.4 Power supply related errors (5xx) ............................................................ C-12
3.5 Communication errors (6xx)..................................................................... C-12
3.6 Calibration errors (7xx)............................................................................. C-14
3.7 System conflicts (8xx) .............................................................................. C-15
3.8 Infrastructure errors (9xx)......................................................................... C-17
Chapter D PREVENTIVE MAINTENANCE
1 SYSTEM MAINTENANCE ......................................................................... D-1
1.1 Cleaning..................................................................................................... D-1
1.2 Operating checks ....................................................................................... D-1

Table of Contents

Other manuals for Planmeca ProMax

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planmeca ProMax and is the answer not in the manual?

Planmeca ProMax Specifications

General IconGeneral
CategoryMedical Equipment
TypeCone Beam Computed Tomography (CBCT) System
SoftwarePlanmeca Romexis
Imaging ModesCBCT
Imaging Modalities2D Panoramic
X-ray GeneratorHigh Frequency Generator
Focal Spot Size0.5 mm
X-ray Tube Voltage60-90 kV
Exposure TimeVaries depending on imaging mode and parameters
DimensionsVaries significantly depending on model and configuration
WeightVaries significantly depending on model and configuration
Power Requirements50/60 Hz
Patient Positioningseated

Related product manuals