RadioLink RC8X User Manual

RadioLink Electronic Limited
www.radiolink.com
14
④ Slide the battery cover back onto the case.
Attention: if your RC8X have plug battery already, but still cannot turn on, please check
below:
① check if the AAA batteries have reverse polarity connection.
② check if the battery box has reverse polarity connection.
③ check if the LiPo battery has reverse polarity connection.
④ check if the AAA batteries have fully charged.
1.2.8.2 Turn on Transmitter
Long press HOME button about 1.5 seconds, the RC8X will shows Radiolink Logo, and the
welcome to Radiolink sound is emitted at the same time, the home page will display this
information as the picture below:
1
The current model name. There are 100 models in total can be select in Model select
menu. Make sure the model’s name on the display is consistent with the actual model before
running. If the model’s name is not consistent with the actual model, the movement of servo,
the steering gear’s action, the neutral position setting will be wrong, it may be damaging the
car.
2
Receiver signal strength. Receiver signal strength will display on the top of the
transmitter screen after the transmitter bind success with the receiver.
3
The battery voltage of transmitter.

RadioLink RC8X Specifications

General

Channels	8
Frequency	2.4GHz
Modulation	FHSS
Telemetry	Yes
Spreading Spectrum	DSSS
Antenna Type	Dual Antenna
Output Signal	PWM, PPM, SBUS
Low Voltage Alert	Yes
Simulator	Yes
Battery Type	LiPo
Voice Alerts	Yes
Display	3.5 inch color screen, 320*480 resolution
Frequency Band	2.4GHz
Operating Voltage	3.5-4.2V
Channel Resolution	4096
Model Type	Helicopter, Airplane, Glider, Multirotor
Compatible Receivers	R8EF, R6FG, R4FGM, R4F
Battery	3.7V 3000mAh LiPo