RadioLink Electronic Limited
www.radiolink.com
If you want to make the steering get the higher sensitivity or make steering more gentle,
click “+” to increase the value, or click “-“ to decrease the value. When the value of EXP is not
0%, click Quick or Slow to switch the value quickly.
Fine tune(left): To set the right and left steering curves separately. The initial value is 0%,
-200% to +200% can be selected.
Fine tune(right)：To set the right and left steering curves separately. The initial value is 0%,
-200% to +200% can be selected. Click “-“ can decrease the value, and click “+” can increase
the value.
Reset: click Reset will make the value back to the default number.
Back: click the button or short press the power button to return to the previous menu.
VTR curve: If the curve type selects VTR, the steering operates will change with a linear
curve from the neutral point to the high point.
Taking the center line of the VTR as the demarcation point, if set the steering curve type as
Quick VTR curve and the VTR rate is 100%, the steering acceleration is completed in the front
80% of the rudder amount range, thus achieving the effect that the first half of the rudder
amount changes faster than the second half. The slow VTR curve is the opposite.
Quick/Slow: +100 indicates the quick VTR rate, and -100 indicates the slow VTR rate.
The vertical cursor line moves in conjunction with the operation of the steering wheel.
VTR rate: the initial value of VTR rate is 0%, -100% to +100% can be selected. With the
change of this value, the sensitivity of left and right steering is adjusted in the same ratio.
To Next Page
Loading...
Need help?
General
