RadioLink Electronic Limited
www.radiolink.com
Attention:
Throttle servo (ESC) operation is delayed so that the drive wheels will not spin even if the throttle
trigger is operated more than necessary. This delay function is not performed when the throttle
trigger is returned and at brake operation.
Mode：All point, High-Low point, Three-point can be selected.
All point mode High-Low point mode Three-point mode
All point：A delay is set over the entire throttle range.
Turn: the initial value is 100, 1 to 100 can be selected, if the value is 100, it means there is no
delay.
Servo operation is delayed.
Return: the initial value is 100, 1 to 100 can be selected, if the value is 100, it means there is no
delay.
Servo operation is delayed.
To Next Page
Loading...
