To Next Page

To Previous Page

Preparing for use

R&S

NRPxxS(N)

14User Manual 1177.5079.02 ─ 15

3 Preparing for use

Here, you can find basic information about setting up the product for the first time.

● Unpacking and checking.........................................................................................14

● Choosing the operating site.................................................................................... 14

● Considerations for test setup.................................................................................. 15

● Connecting to a DUT...............................................................................................15

● Powering the power sensor.....................................................................................16

● Connecting a cable to the host interface.................................................................17

● Connecting to a controlling host..............................................................................17

3.1 Unpacking and checking

1. Unpack the product carefully.

2. Retain the original packing material. Use it when transporting or shipping the prod-

uct later.

3. Using the delivery notes, check the equipment for completeness.

4. Check the equipment for damage.

If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.

3.2 Choosing the operating site

Specific operating conditions ensure proper operation and avoid damage to the prod-

uct and connected devices. For information on environmental conditions such as ambi-

ent temperature and humidity, see the data sheet.

Electromagnetic compatibility classes

The electromagnetic compatibility (EMC) class indicates where you can operate the

product. The EMC class of the product is given in the data sheet.

●

Class B equipment is suitable for use in:

– Residential environments

– Environments that are directly connected to a low-voltage supply network that

supplies residential buildings

●

Class A equipment is intended for use in industrial environments. It can cause

radio disturbances in residential environments due to possible conducted and radi-

ated disturbances. It is therefore not suitable for class B environments.

If class A equipment causes radio disturbances, take appropriate measures to

eliminate them.

Choosing the operating site

R&S NRP Series User Manual

Other manuals for R&S NRP Series