To Next Page

To Previous Page

Firmware update

R&S

NRPxxS(N)

59User Manual 1177.5079.02 ─ 15

8. Check if the update was successful. The firmware version in the "Identification"

field must match the version you selected in the "Firmware" field.

Troubleshooting

You do not find the sensor in the list of sensors provided by Firmware Update for NRP

Family.

The driver assigned to the sensor is the legacy driver.

► Install a recent VISA software.

The power sensor is highlighted by a yellow exclamation mark in the Windows device

manager.

Windows tries in vain to find a USB driver for the power sensor.

► Install a recent VISA software.

Further information:

●

Chapter 12.3, "Problems during a firmware update", on page 171

7.2.2 Using the web user interface

1. Connect the power sensor to the computer as described in Chapter 3.7.1, "Com-

puter", on page 18.

2. Open the web user interface as described in Chapter 5.2, "Browser-based user

interface", on page 34.

3. In the navigation pane, select "System".

4. Click "Firmware Update".

5. In the "Firmware Update" dialog, click "Select RSU file".

6. In the file browser, select the *.rsu file for upload.

The selected *.rsu is displayed, for example NRPxSN_02.30.21062301.rsu.

Updating the firmware

R&S NRP Series User Manual

Other manuals for R&S NRP Series