R&S NRP Series - Configuring the Trigger; Remote Commands; Trigger:atrigger:delay; Trigger:atrigger:executed

Remote control commands
R&S
®
NRPxxS(N)
83User Manual 1177.5079.02 ─ 15
9.5.5 Configuring the trigger
Further information:
●
Chapter 9.5, "Controlling the measurement", on page 73
Remote commands:
TRIGger:ATRigger:DELay.................................................................................................83
TRIGger:ATRigger:EXECuted?..........................................................................................83
TRIGger:ATRigger[:STATe]................................................................................................84
TRIGger:COUNt.............................................................................................................. 84
TRIGger:DELay............................................................................................................... 84
TRIGger:DELay:AUTO..................................................................................................... 84
TRIGger:DTIMe............................................................................................................... 85
TRIGger:EXTernal<2...2>:IMPedance................................................................................ 85
TRIGger:HOLDoff............................................................................................................ 85
TRIGger:HYSTeresis........................................................................................................86
TRIGger:IMMediate..........................................................................................................86
TRIGger:LEVel................................................................................................................ 86
TRIGger:LEVel:UNIT........................................................................................................87
TRIGger:SENDer:PORT................................................................................................... 87
TRIGger:SENDer:STATe...................................................................................................87
TRIGger:SLOPe.............................................................................................................. 87
TRIGger:SOURce............................................................................................................ 88
TRIGger:SYNC:PORT......................................................................................................88
TRIGger:SYNC:STATe......................................................................................................88
TRIGger:ATRigger:DELay <delay>
Effective only if TRIGger:ATRigger[:STATe] is set to ON.
Sets the delay between the artificial trigger event and the beginning of the actual mea-
surement
Parameters:
<delay> Range: 0.1 to 5.0
*RST: 0.3
Default unit: Seconds
TRIGger:ATRigger:EXECuted?
Queries the number of measurements that were triggered automatically since
TRIGger:ATRigger[:STATe] was set to ON.
In normal scalar measurements, this number can only be 0 or 1. If a buffered measure-
ment was executed, this number indicates how many results in the returned array of
measurement data were executed without a real trigger event.
Usage:
Query only
Controlling the measurement