Remote control commands
R&S
®
NRPxxS(N)
94User Manual 1177.5079.02 ─ 15
[SENSe<Sensor>:][POWer:][AVG:]FAST <state>
Enables or disables a fast unchopped continuous average measurement. If enabled,
the average count is enforced to 1, and any setting for average count is silently
ignored.
You can increase the measurement accuracy by increasing the duration of the sam-
pling window using:
[SENSe<Sensor>:][POWer:][AVG:]APERture.
The fast measurement setting delivers up to 100 000 measurements per second with-
out any blind time over randomly long time periods.
See also "Calculating the measurement time" on page 91.
Parameters:
<state> *RST: OFF
Example:
FAST ON
See Chapter 10.2, "Performing the fastest measurement in con-
tinuous average mode", on page 143.
[SENSe<Sensor>:][POWer:][AVG:]SMOothing:STATe <state>
Enables or disables the smoothing filter, a steep-edge digital lowpass filter. If you can-
not adjust the aperture time exactly to the modulation period, the filter reduces result
fluctuations caused by modulation.
Parameters:
<state> ON | OFF
*RST: OFF
Example:
SMO:STAT OFF
Manual operation: See "Smoothing" on page 46
9.7.2 Burst average measurement
The burst average mode is used to measure the average power of bursts. The integra-
tion time of a measurement is not predefined but determined by the power sensor with
the aid of a burst detector. The start of a burst is detected when the measurement sig-
nal rises above a set trigger level. The measurement ends when the signal drops
below a trigger threshold.
Configuring the measurement modes
To Next Page
Loading...
Need help?
General
