R&S NRP Series - Settings

Browser-based user interface
R&S
®
NRPxxS(N)
49User Manual 1177.5079.02 ─ 15
Trace Time.................................................................................................................... 49
Trace Offset Time..........................................................................................................49
Trace Points.................................................................................................................. 49
Trace Time
Sets the trace length.
Remote command:
[SENSe<Sensor>:]TRACe:TIME
Trace Offset Time
Sets the relative position of the trigger event in relation to the beginning of the trace
measurement sequence. Used to specify the start of recording for the trace mode.
Remote command:
[SENSe<Sensor>:]TRACe:OFFSet:TIME
Trace Points
Sets the number of required values per trace sequence. For achieving a good optimum
between the measurement speed and the resolution, you can set a value of 200 trace
points.
Remote command:
[SENSe<Sensor>:]TRACe:POINts
6.5 Settings
Describes the parameters for general sensor configuration.
● Sensor settings....................................................................................................... 49
● Averaging settings...................................................................................................51
● Trigger settings....................................................................................................... 52
● System settings.......................................................................................................53
6.5.1 Sensor settings
Describes the parameters for optimizing the measurement results for specific measure-
ment requirements.
Further information:
●
Chapter 9.4.2, "Selecting a measurement path", on page 70
●
Chapter 9.8.4, "Configuring corrections", on page 108
●
Chapter 9.10, "Calibrating, zeroing", on page 124
●
Chapter 9.11, "Testing", on page 126
Access: main dialog of the web user interface > navigation pane > "Sensor"
Settings