To Next Page

To Previous Page

Remote control commands

R&S

NRPxxS(N)

124User Manual 1177.5079.02 ─ 15

FETCh<Sensor>[:SCALar][:POWer][:AVG]?

Queries the last valid measurement result of the measurand that was configured

before.

To configure the measurand, use CALCulate:FEED before the measurement is initi-

ated.

Usage: Query only

FETCh<Sensor>[:SCALar][:POWer]:BURSt?

Queries the last valid measurement result in burst average mode.

To configure the measurand, use CALCulate:FEED before the measurement is initi-

ated.

Usage:

Query only

FETCh<Sensor>[:SCALar][:POWer]:TSLot?

Queries the last valid measurement result in timeslot mode.

To configure the measurand, use CALCulate:FEED before the measurement is initi-

ated.

Usage:

Query only

9.10 Calibrating, zeroing

Zeroing removes offset voltages from the analog circuitry of the power sensor, so that

there are only low powers displayed if no power applied. The zeroing process can take

more than 8 seconds to complete.

Zeroing is recommended if:

●

The temperature has varied by more than 5 K.

●

The power sensor has been replaced.

●

No zeroing was performed in the last 24 hours.

●

Signals of very low power are to be measured, for instance, if the expected mea-

sured value is less than 10 dB above the lower measurement range limit.

Turn off all test signals before zeroing. An active test signal during zeroing causes an

error.

Remote commands:

Calibrating, zeroing

R&S NRP Series User Manual

Other manuals for R&S NRP Series