Remote control commands
R&S
®
NRPxxS(N)
68User Manual 1177.5079.02 ─ 15
*OPC? basically functions like *WAI, but also returns a response. The response is an
advantage, because you can query the execution of commands from a controller pro-
gram before sending new commands. Thus preventing overflow of the input queue
when too many commands are sent that cannot be executed.
*OPT?
Option identification
Returns a comma-separated list of installed options.
Usage: Query only
*PRE
<register>
Parallel poll register enable
Sets the parallel poll enable register to the specified value or queries the current value.
Parameters:
<register> Range: 0 to 255
*RST: 0
*RCL <number>
Recall
Calls the device state which has been stored with the *SAV command under the speci-
fied number.
Setting parameters:
<number> Range: 0 to 9
*RST: 0
Usage: Setting only
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
The command corresponds to the SYSTem:PRESet command.
Usage:
Event
*SAV <number>
Save
Stores the current device state under the specified number.
Common commands
To Next Page
Loading...
