To Next Page

To Previous Page

Browser-based user interface

R&S

NRPxxS(N)

48User Manual 1177.5079.02 ─ 15

Number of Timeslots..................................................................................................... 48

Nominal Width...............................................................................................................48

Start Exclude.................................................................................................................48

End Exclude..................................................................................................................48

Number of Timeslots

Sets the number of simultaneously measured timeslots. Up to eight slots can be

selected.

Remote command:

[SENSe<Sensor>:][POWer:]TSLot[:AVG]:COUNt

Nominal Width

Sets the length of a timeslot in seconds.

Remote command:

[SENSe<Sensor>:][POWer:]TSLot[:AVG]:WIDTh

Start Exclude

Sets a time that is to be excluded at the beginning of the measurement period.

Remote command:

[SENSe<Sensor>:]TIMing:EXCLude:STARt

End Exclude

Sets a time that is to be excluded at the end of the measurement period.

Remote command:

[SENSe<Sensor>:]TIMing:EXCLude:STOP

6.4.4 Trace mode

Describes the parameters of the trace measurement.

Further information:

●

Chapter 9.7.4, "Trace measurement", on page 98

Detailed description of the trace measurement mode and its remote commands

Access: main dialog of the web user interface > navigation pane > "Trace"

Measurement modes

R&S NRP Series User Manual

Other manuals for R&S NRP Series