R&S NRP Series - R&S NRP Toolkit for Windows

Operating concepts
R&S
®
NRPxxS(N)
32User Manual 1177.5079.02 ─ 15
Supported Microsoft Windows versions:
●
Microsoft Windows Vista 32/64-bit
●
Microsoft Windows 7 32/64-bit
●
Microsoft Windows 8/ 8.1 32/64-bit
●
Microsoft Windows 10 32/64-bit
5.1.3 R&S NRP Toolkit for Windows
The R&S NRP Toolkit installer for Windows-based systems contains the components
described in the release notes available at www.rohde-schwarz.com/software/nrp-tool-
kit.
To install the R&S NRP Toolkit
1. Start the R&S NRP Toolkit installer on the Windows-based computer.
In the "NRP-Toolkit Setup" dialog, the correct R&S NRP Toolkit version for your
operating system, 32-bit or 64-bit, is already selected.
2. Enable the components you want to install.
● "NRP-Toolkit (SDK)"
The software development kit (SDK) provides programming examples for the
R&S power sensors.
See Chapter 10, "Performing measurement tasks - programming examples",
on page 143.
● "IVI Shared Components"
Installs the USBTMC driver. Enabled by default because the installation is rec-
ommended.
See also Table 11-1.
R&S NRP Toolkit