R&S RTC1000 - Page 296

Remote Commands Reference
R&S
®
RTC1000
296User Manual 1335.7352.02 ─ 02
<n> Selects the frame.
<o> Selects the word number.
Return values:
<Status> OK | FRSTart | FRENd | FRMError | STERror | SPERror |
PRERror | INSufficient
OK
Frame is o.k.
FRSTart
Frame start
FRENd
Frame end
FRMError
Frame error
STERror
Startbit error
SPERror
Stopbit error
PRERror
Parity error
INSufficient
Frame is insufficient
*RST:
OK
Usage: Query only
13.16.7 CAN
● CAN - Configuration..............................................................................................296
● Trigger...................................................................................................................298
● Decode..................................................................................................................301
13.16.7.1 CAN - Configuration
BUS<b>:CAN:DATA:SOURce......................................................................................... 296
BUS<b>:CAN:TYPE.......................................................................................................297
BUS<b>:CAN:SAMPlepoint.............................................................................................297
BUS<b>:CAN:BITRate................................................................................................... 297
BUS<b>:CAN:DATA:SOURce <Source>
Sets the input channel to which the data line is connected.
Suffix:
<b>
.
1, 2
Selects the bus.
Protocol Analysis