R&S ZNA67 - Calculate<Chn>:Limit:lower:shift; Calculate<Chn>:Limit:upper:feed; Calculate<Chn>:Limit:upper:shift

Command reference
R&S
®
ZNA
976User Manual 1178.6462.02 ─ 20
CALCulate<Chn>:LIMit:LOWer:SHIFt <LimShift>
CALCulate<Chn>:LIMit:UPPer:SHIFt <LimShift>
These commands shift all lower and upper limit line segments assigned to the active
trace in vertical direction. Both commands shift all limit lines; they have the same func-
tionality. See also Chapter 4.4.1.1, "Rules for limit line definition", on page 141.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Setting parameters:
<LimShift> Response offset value for all limit line segments.
Range: Virtually no restriction for limit segments
Default unit: NN
Example: See CALCulate<Chn>:LIMit:LOWer:FEED
Usage: Setting only
Manual operation: See "Shift Lines" on page 435
CALCulate<Chn>:LIMit:SEGMent<Seg>:AMPLitude:STARt <Response>
CALCulate<Chn>:LIMit:SEGMent<Seg>:AMPLitude:STOP <Response>
These commands change the start or the stop response values (i.e. the response val-
ues assigned to the start or stop stimulus values) of a limit line segment. A segment
must be created first to enable the commands (e.g CALCulate<Chn>:LIMit:DATA).
See also Chapter 4.4.1.1, "Rules for limit line definition", on page 141.
Tip: To define the response values of several limit line segments with a single com-
mand, use CALCulate<Chn>:LIMit:LOWer[:DATA] or CALCulate<Chn>:
LIMit:UPPer[:DATA].
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Seg> Segment number
Parameters:
<Response> Response value
Range: Virtually no restriction for limit segments
*RST: The default response values of a segment that is
created by defining its stimulus values only (e.g. by
means of CALCulate<Ch>:LIMit:CONTrol[:DATA]),
are -40 dB.
Default unit: NN
SCPI command reference