GUI reference
R&S
®
ZNA
636User Manual 1178.6462.02 ─ 20
Range
If Segmented IF Gain is enabled, each sweep segment can be configured separately.
Remote command:
[SENSe<Ch>:]SEGMent<Seg>:POWer:GAINcontrol
[SENSe<Ch>:]SEGMent<Seg>:POWer:GAINcontrol:ALL
Drive-port specific settings
"Drive Port", "a<i>", "b<j>": Selects the wideband / narrowband IF gain mode for the
respective drive port, a and b wave and receivers.
Remote command:
[SENSe<Ch>:]POWer:GAINcontrol
Set All Items to ...
Convenience functions to apply the same manual wideband / narrowband IF gain
mode to all a and b wave receivers.
If Segmented IF Gain is enabled, the setting only applies to the selected segment.
Remote command:
[SENSe<Ch>:]POWer:GAINcontrol:ALL
5.13.2 Pulse Mod tab
Gives access to the pulse generation, pulse modulation, and pulse profile measure-
ment functionality of the R&S ZNA.
As outlined in the table below, the related functionality is enabled by several hardware
and software options.
Table 5-6: Related Options
Option Functionality
Pulse Generator Pulse Modulator
Control
Pulse Modulator Pulse Profile Mea-
surement
Trigger board
(R&S ZNA-B91)
all ports via Trig Out and
PuMo In/Out
– –
Internal pulse mod-
ulators
(Option
R&S ZNAxx-B41|
B42|B43|B44)
all ports – Option
R&S ZNAxx-B4y
enables the inter-
nal pulse modula-
tor of port y
–
Option R&S ZNA-
K7
(R&S ZNA-K7)
Advanced pulse
generation (individ-
ual pulse widths/
delays per port,
pulse trains)
– –
✓
The "Pulse Profile" measurement mode is enabled by selecting the corresponding
sweep type (see Chapter 5.10.2, "Sweep Type tab", on page 491).
Mode softtool
To Next Page
Loading...
