R&S ZNA67 - Print Tab

GUI reference
R&S
®
ZNA
710User Manual 1178.6462.02 ─ 20
Favorites combo-box / Remove
Use the "Favorites" combo-box to select the favorite to be removed from the list, then
select "Remove"
5.15.3 Print tab
The buttons on the "Print" tab allow you to send the diagrams of the active setup to an
external printer, to a file or to the clipboard. Content and layout can be defined in the
Printer Setup dialog.
Print
Prints the diagrams using the current content, printer and page settings (see Chap-
ter 5.15.4, "Printer Setup dialog", on page 711).
Remote command:
The HCOPy... commands provide the printer settings; see Chapter 7.3.7, "HCOPy
commands", on page 1165.
HCOPy[:IMMediate] initiates printing.
Print...
Opens a dialog that allows to define the content, printer and page settings (see Chap-
ter 5.15.4, "Printer Setup dialog", on page 711).
To File...
Opens the "Save Image" dialog that allows you to select a graphics file type
(*.bmp, *.jpg | *.jpeg, *.pdf, *.png, *.svg) and to save diagram con-
tent to a file of this type (see also "Save Dialog" on page 111).
Note that the diagram content to be saved can be configured in the Content tab >
"Print Charts" group of the "Printer Setup" dialog. E.g., if you select "All diagrams on
their own page" there, then only the content of the active diagram is saved to file. If you
select "No diagram at all", then "To File..." is disabled.
Remote command:
HCOPy:DESTination
To Clipboard
Copies diagram content to the clipboard, from where you can paste it into another
application.
File Print softtool