R&S ZNA67 - Initiate Commands

Command reference
R&S
®
ZNA
1170User Manual 1178.6462.02 ─ 20
HCOPy:PAGE:ORIentation <Orientation>
Defines the orientation of the printed page. Switching between LANDscape and
PORTrait rotates the hardcopy result by 90 degrees. No other settings are changed.
Parameters:
<Orientation> LANDscape | PORTrait
LANDscape - long edge of the paper is the top of the page.
PORTrait - short edge of the paper is the top of the page.
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:ORI LAND; :HCOP
Select landscape page orientation and start printing.
HCOPy:PAGE:WINDow <PrintDiagram>
Defines how the diagrams shall be printed (using HCOPy[:IMMediate].
Parameters:
<PrintDiagram> ALL | SINGle | ACTive | HARDcopy | NONE
ALL - all diagrams are printed on one page.
SINGle - one diagram per page.
ACTive - print only active diagram.
HARDcopy - print a screenshot of the diagram area, preserving
layout and colors ("real screenshot")
NONE - print no diagram at all.
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:WIND SING; :HCOP
Select one diagram per page and start printing.
7.3.8 INITiate commands
The INITiate... commands control the initiation of the trigger system and define
the scope of the triggered measurement.
INITiate[:IMMediate]:ALL...............................................................................................1170
INITiate:CONTinuous:ALL............................................................................................. 1171
INITiate<Ch>[:IMMediate][:DUMMy]............................................................................... 1171
INITiate<Ch>[:IMMediate]:SCOPe..................................................................................1172
INITiate<Ch>:CONTinuous............................................................................................1172
INITiate<Ch>:CTIMing.................................................................................................. 1173
INITiate[:IMMediate]:ALL
Starts a new single sweep sequence in all channels. This command is available in sin-
gle sweep mode only (INITiate:CONTinuous:ALL OFF). The data of the last sweep
(or of previous sweeps, see Retrieving the results of previous sweeps) can be read
using CALCulate<Chn>:DATA:NSWeep:FIRSt? SDATa, <count>.
SCPI command reference