R&S ZNA67 - Noise Figure Tab

GUI reference
R&S
®
ZNA
322User Manual 1178.6462.02 ─ 20
Port
Allows you to select the source for the stimulus signal.
●
"None", "Port <Pt>", or "Conv <Pt>", if Use Generator as Source is not checked
●
"Gen <i>" if "Use Generator as Source" is checked
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "<Ratio>"
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "<Ratio>"
Detector
Selects the algorithm that is used to calculate the results points from the raw measure-
ment data.
For details refer to Chapter 4.3.5.3, "Detector settings", on page 133.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
[SENSe<Ch>:]SWEep:DETector:TIME
5.2.5 Noise Figure tab
Noise figure measurements are available for both non-frequency converting and fre-
quency converting DUTs.
The noise figure measurement is provided with software option R&S ZNA-K30. If this
option is not installed, the "Noise Figure" tab is not available.
For background information, see Chapter 4.7.11, "Noise figure measurement",
on page 260.
Access: Trace – [Meas] > "Noise Figure"
5.2.5.1 Controls on the Noise Figure tab
The controls on the "Noise Figure" tab allow you to set up a noise figure (NF) measure-
ment and give access to the related measured quantities.
Meas softtool