R&S ZNA67 - Calculate<Ch>:Transform:vnetworks:differential:embedding<Logpt>:Tndefinition; Calculate<Ch>:Transform:vnetworks:gloop:deembedding<Group>[:State]; Parameters:r<Cmp

Command reference
R&S
®
ZNA
1079User Manual 1178.6462.02 ─ 20
CALCulate<Ch>:TRANsform:VNETworks:DIFFerential:EMBedding<LogPt>:
PARameters:R<Cmp> <CircuitModel>[, <Resistance>]
Specifies the resistance value R in the "Shunt L, Shunt C" lumped element model for
differential match embedding.
In the query form, the <Resistance> parameter must be omitted.
Suffix:
<Ch>
.
Channel number
<LogPt> Logical port number (balanced port)
<Cmp> Must be omitted or set to 1.
Parameters:
<CircuitModel> SHLC
Currently only the "Shunt L, Shunt C" lumped element model is
supported
<Resistance> Range: -10 MΩ to 10 MΩ.
Increment: 1 mΩ (1E-3 Ω)
*RST: 0 Ω
Default unit: Ohm
Manual operation: See "Network" on page 696
CALCulate<Ch>:TRANsform:VNETworks:DIFFerential:EMBedding<LogPt>:
TNDefinition <CircuitModel>
Selects the circuit model for differential match embedding.
Suffix:
<Ch>
.
Channel number
<LogPt> Logical port number (balanced port)
Parameters:
<CircuitModel> FIMPort | SHLC
Possible circuit models (character data), see Circuit models for
differential match embedding
Manual operation: See "Network" on page 696
CALCulate<Ch>:TRANsform:VNETworks:GLOop:DEEMbedding<group>[:STATe]
<Boolean>
Enables or disables the deembedding function for ground loops. It is allowed to change
the circuit model and its parameters while deembedding is enabled.
Suffix:
<Ch>
.
Channel number.
SCPI command reference