R&S ZNA67 - Delta-L Tab

GUI reference
R&S
®
ZNA
698User Manual 1178.6462.02 ─ 20
Top = Default offset calculation
Bottom = Offset calculation after de-/embedding (GUI mockup)
Remote command:
[SENSe:]CORRection:EDELay:VNETwork
Offset > Wave De-/Embed.
If checked, the firmware uses the new, wave-based de-/embedding calculation
(default). Otherwise, the legacy S parameter-based calculation is used. See Chap-
ter 4.1.6, "Data flow", on page 93.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:WAVes
5.14.11 Delta-L tab
The controls on the "Delta-L" tab allow you to set up and perform a Delta-L PCB char-
acterization.
The "Delta-L" tab is only visible if option R&S ZNA-K231 is installed on the instrument.
See Chapter 4.7.17, "Delta-L 4.0 PCB characterization", on page 271.
Offset Embed softtool