R&S ZNA67 - Diagnostic Commands

Command reference
R&S
®
ZNA
1135User Manual 1178.6462.02 ─ 20
*RST: 0
Manual operation: See "Local VSE" on page 645
CONTrol:VSE:MODE <VseMode>
Determines where the acquired measurement data are processed.
Parameters:
<VseMode> DEVice | VSE | BOTH
DEVice
Only on the R&S ZNA
VSE
Only on the R&S VSE
BOTH
On the R&S ZNA and on the R&S VSE
Manual operation: See "VSE Mode" on page 637
CONTrol:VSE:TRACe <No>
Select the trace to be pushed to R&S VSE, if connected (see CONTrol:VSE:
CONNect) and enabled (see CONTrol:VSE:MODE).
Parameters:
<No> Trace number
Manual operation: See "Trace (b-wave)" on page 638
7.3.4 DIAGnostic commands
The DIAGnostic... commands provide access to service and diagnostic routines
used in service, maintenance and repair. In accordance with the SCPI standard, all
commands are device-specific.
Service functions are password-protected (SYSTem:PASSword[:CENable]) and are
intended for Rohde & Schwarz service staff. Refer to the service manual for more infor-
mation.
DIAGnostic:DEVice:STATe............................................................................................ 1135
DIAGnostic:DUMP:SIZE................................................................................................1136
DIAGnostic:PRODuct:OPTion:INFO?............................................................................. 1136
DIAGnostic:SERVice:RFPower......................................................................................1136
DIAGnostic:SERVice:SFUNction....................................................................................1137
DIAGnostic:DEVice:STATe <Filename>
Generates a system report and writes it to the specified file. See Chapter 9.3, "Collect-
ing information for technical support", on page 1634.
SCPI command reference