R&S ZNA67 - Suffix

Command reference
R&S
®
ZNA
955User Manual 1178.6462.02 ─ 20
CALCulate:FMODel:SFD...
Commands for PacketMicro's Smart Fixture De-embedding (SFD), see https://
www.packetmicro.com/Products/sfd-tool.html
CALCulate:FMODel:SFD<Ph_pt>:AUTO.......................................................................... 955
CALCulate:FMODel:SFD<Ph_pt>:COUPon:MEASure....................................................... 955
CALCulate:FMODel:SFD<Ph_pt>:COUPon:MEASure:FILename........................................955
CALCulate:FMODel:SFD<Ph_pt>:COUPon:MEASure:FILename:CLEar..............................956
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe].......................................................... 956
CALCulate:FMODel:SFD<Ph_pt>:COUPon:TYPE.............................................................956
CALCulate:FMODel:SFD<Ph_pt>:DIFFcfg........................................................................957
CALCulate:FMODel:SFD<Ph_pt>:DUT:MEASure.............................................................. 957
CALCulate:FMODel:SFD<Ph_pt>:DUT:MEASure:FILename...............................................957
CALCulate:FMODel:SFD<Ph_pt>:DUT:MEASure:FILename:CLEar.................................... 957
CALCulate:FMODel:SFD<Ph_pt>:PRESet........................................................................958
CALCulate:FMODel:SFD<Ph_pt>:DUT[:STATe].................................................................958
CALCulate:FMODel:SFD<Ph_pt>:RUN:RUN.................................................................... 958
CALCulate:FMODel:SFD<Ph_pt>:RUN[:STATe]................................................................ 959
CALCulate:FMODel:SFD<Ph_pt>:TOTaldiffcfg..................................................................959
CALCulate:FMODel:SFD<Ph_pt>:AUTO <Boolean>
Defines whether the SFD tool shall perform automatic impedance adjustments.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<Boolean>
Manual operation: See "Adjust Impedance Mismatch" on page 686
CALCulate:FMODel:SFD<Ph_pt>:COUPon:MEASure
For a fixture modeling with the SFD tool, this command starts the measurement of the
coupon at the active ports (see CALCulate:FMODel:SFD<Ph_pt>:COUPon[:
STATe]).
The coupon type can be selected using CALCulate:FMODel:SFD<Ph_pt>:
COUPon:TYPE.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Manual operation: See "Measure / Measure Open / Measure Short" on page 676
CALCulate:FMODel:SFD<Ph_pt>:COUPon:MEASure:FILename <String>
For a fixture modeling with the SFD tool, this command loads the coupon properties
from a Touchstone file.
SCPI command reference