R&S ZNA67 - Calculate<Ch>:Transform:vnetworks:ppair:deembedding:delete; Calculate<Ch>:Transform:vnetworks:ppair:deembedding<Listid>[:State]

Command reference
R&S
®
ZNA
1088User Manual 1178.6462.02 ─ 20
CALCulate<Ch>:TRANsform:VNETworks:FSIMulator[:STATe] <Enable>
De/activates the "Fixture Simulator" switch that allows to disable and (re-)enable the
configured deembedding, embedding, balanced ports, and port impedance settings for
the selected channel.
Suffix:
<Ch>
.
Channel number
Parameters:
<Enable>
Manual operation: See "Fixture Simulator" on page 600
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding:DELete
Deletes all port sets (including port pairs) previously defined for deembedding.
Suffix:
<Ch>
.
Channel number
Example: See CALCulate<Ch>:TRANsform:VNETworks:PPAir:
DEEMbedding<ListId>[:STATe]
Usage: Event
Manual operation: See "Add / Delete" on page 655
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding<ListId>[:STATe]
<arg0>
Enables or disables the deembedding function for port set (or port pair) <ListId>. It is
allowed to change the deembedding network while embedding is enabled.
Suffix:
<Ch>
.
Channel number
<ListId> Index of the affected port set
Parameters:
<arg0> OFF (0): Deembedding inactive
ON (1): Deembedding active
*RST: OFF (0)
Example:
*RST; CALC:TRAN:VNET:PPA:DEEM:DEF 1,2,3,4
Define a port pair configuration with port pairs (1,2) and (3,4).
CALC:TRAN:VNET:PPA:DEEM1:TND CSSL
Select the Serial Cs, shunt L circuit model for the first port pair.
CALC:TRAN:VNET:PPA:DEEM1:PAR:
R3 CSSL, 2.2E+3; CALC:TRAN:VNET:PPA:DEEM1 ON
Increase the resistance R3 for the Serial Cs, shunt L circuit
model to 2.2 kΩ and enable deembedding.
CALC:TRAN:VNET:PPA:DEEM:DEL
Delete the port pair configuration.
SCPI command reference