R&S ZNA67 - Spectrum Tab

GUI reference
R&S
®
ZNA
351User Manual 1178.6462.02 ─ 20
Source Port
Selects one of the available test ports of the analyzer as a source of the stimulus sig-
nal.
Remote command:
CALCulate<Ch>:PARameter:MEASure 'TraceName', 'PmtrD1 | ...
CALCulate<Ch>:PARameter:SDEFine 'TraceName', 'PmtrD1 | ...
Show as
Selects the physical unit of the displayed trace. It is possible to display the measured
"Voltage" V or convert it to a "Power" according to the formula
P = V
2
/Re(Z
0
).
Z
0
denotes the reference impedance of the source port. The reference impedances are
defined in the "Balanced Ports" dialog (see Chapter 5.2.2.5, "Balanced Ports dialog",
on page 311).
Remote command:
CALCulate<Chn>:FORMat:WQUType
Port Settings...
Opens the Port Settings dialog.
5.2.11 Spectrum tab
The "Spectrum" tab allows you to set up spectrum measurements.
Spectrum measurements require software option R&S ZNA-K1. If this option is not
installed, the "Spectrum" tab is hidden.
Meas softtool