R&S ZNA67 - Calculate<Chn>:Statistics:nlinear:comp[:State]; Calculate<Chn>:Statistics:rdomain:user; Calculate<Chn>:Statistics:rdomain:user:show

Command reference
R&S
®
ZNA
1040User Manual 1178.6462.02 ─ 20
Parameters:
<Phase> Reference phase
*RST: 1°
Default unit: deg
Manual operation: See "Defined Value" on page 415
CALCulate<Chn>:STATistics:NLINear:COMP[:STATe] <Boolean>
Displays or hides the compression point result in the diagram area channel <Chn>'s
active trace..
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON | OFF - statistical info field on or off.
*RST: OFF
Example: See CALCulate<Chn>:STATistics:NLINear:COMP:
RESult?
Manual operation: See "Compr. Point / Compr. Val." on page 413
CALCulate<Chn>:STATistics:RDOMain:USER <EvalRange>
Selects one of the 10 channel-specific user defined ranges as the reference range for
spectrum power ratio calculations.
The selected range can then be configured with the CALCulate<Chn>:
STATistics:RDOMain:USER:STARt, CALCulate<Chn>:STATistics:RDOMain:
USER:STOP, and CALCulate<Chn>:STATistics:RDOMain:USER:SHOW com-
mands.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<EvalRange>
Options: R&S ZNA-K1
Manual operation: See "Ref. Range" on page 415
CALCulate<Chn>:STATistics:RDOMain:USER:SHOW <Boolean>
Displays or hides range limit lines for the reference range selected via
CALCulate<Chn>:STATistics:RDOMain:USER.
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI command reference