R&S ZNA67 - Page 1041

Command reference
R&S
®
ZNA
1041User Manual 1178.6462.02 ─ 20
Parameters:
<Boolean> ON | OFF – reference range limit lines on or off.
*RST: OFF
Options: R&S ZNA-K1
Manual operation: See "Ref. Range" on page 415
CALCulate<Chn>:STATistics:RDOMain:USER:STARt <Start>
CALCulate<Chn>:STATistics:RDOMain:USER:STOP <Value>
Defines the start/stop value of the range selected via CALCulate<Chn>:
STATistics:RDOMain:USER.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Stop> Start/stop value of the related range
Default unit: Hz
Options: R&S ZNA-K1
Manual operation: See "Ref. Range" on page 415
CALCulate<Chn>:STATistics:PRATio[:STATe] <Boolean>
Displays or hides the power ratio statistics in the diagram area of spectrum analysis
channel <Chn>'s active trace.
Use CALCulate<Chn>:STATistics:PRATio:RESult? to query the results.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON | OFF – info field on or off.
*RST: OFF
Options: R&S ZNA-K1
Manual operation: See "Power Ratio" on page 413
CALCulate<Chn>:STATistics:PRATio:RESult?
Returns the power ratio staticstics (three comma-separated numeric values) of a spec-
trum analysis trace:
●
Power density in reference range
(see CALCulate<Chn>:STATistics:RDOMain:USER)
●
Power density in evaluation range
(see CALCulate<Chn>:STATistics:DOMain:USER)
●
Power ratio (trace value vs. reference range)
SCPI command reference