R&S ZNA67 - Page 415

GUI reference
R&S
®
ZNA
415User Manual 1178.6462.02 ─ 20
Ref. Range
This button is visible if either:
●
Compression point statistics are calculated and "Range" is used as Reference
Value
●
The current channel is in spectrum analysis mode
It opens the "Reference Range" dialog that allows you to configure the sweep range
whose average value shall be used as the reference ("small signal value") for the com-
pression point calculation or as the reference power for the Power Ratio calculation.
Remote command:
Compression point statistics:
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:STARt
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:STOP
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:SHOW
Power ratio statistics (spectrum analysis) :
CALCulate<Chn>:STATistics:RDOMain:USER on page 1040
CALCulate<Chn>:STATistics:RDOMain:USER:STARt on page 1041
CALCulate<Chn>:STATistics:RDOMain:USER:STOP on page 1041
CALCulate<Chn>:STATistics:RDOMain:USER:SHOW on page 1040
Defined Value
This setting is only visible if "Defined Value" is used as Reference Value. It manually
defines the reference value ("small signal value") for the compression point calculation.
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP:RLEVel
CALCulate<Chn>:STATistics:NLINear:COMP:RPHase
5.5.8.2 Evaluation Range dialog
The "Evaluation Range" dialog defines the range for various trace evaluation opera-
tions (trace statistics, offset, loss and fixture compensation calculations). The evalua-
tion range is a continuous interval of the sweep variable.
Traces softtool